top of page

Setting up firmware is hard

I suppose this counts as coding. I am guided by the light of google and a handful of helpful community guides. This is just some casual proof that I started preparing this. I cannot test it without the actual main board arriving.

Really looking forward to getting more parts in the mail. I am expecting things like bed plates arriving end of the week and linear rods a week after. Smaller parts arriving sporadically during that time.

I am planning to finish printing what I need for the electronics enclosure by the end of the day.


0 views0 comments

Recent Posts

See All

Going Dual Z-Axis

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Two Cetus's Functional, One to go, Rebuilding Code

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr

bottom of page