top of page
Search

Screwing up


Haha, like my pun? All is good, I just finished a handful of parts with more screws and nuts. I have to pay special attention to make sure hole depths, clearances, and overhangs are counted for each part to ensure they can be 3D printed with as little clean up as possible.


Cheers!

0 views0 comments

Recent Posts

See All

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr

bottom of page