top of page

Rough Assembly and Filament Guide

I have worked out a slap dash way to get all the hardware into the extruder as well as a narrow filament guiding piece to ensure a smooth flow especially for inserting and removing filament. The odd shape means I need to make a lot of adjustments to the tensioning lever arm and elsewhere around the machine. A time consuming process with a very unorthodox solution to jam detection. Normally people use expensive and complex laser/light sensors for this process so we will see how this more mechanical idea goes.


2 views0 comments

Recent Posts

See All

Going Dual Z-Axis

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Two Cetus's Functional, One to go, Rebuilding Code

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr


bottom of page