top of page

Polished and Hypothetically Functional

I'll be working on a cover for the red sensor tomorrow but I am happy to announce that I got every piece inside without collisions and this should work as intended if I print it. The lever arm is a bit more fragile than I would like so I might bulk it up where I can but the true test will be how well this holds up against 1000 hrs of printing. If this piece works well, I can use it on all my future printer builds without modification.

I might also be getting ahead of myself but I have been pondering an enclosed delta and ultimaker style of printer for my next build. I want a respectable range of products people can choose from and to push the 3D printing medium forward.


2 views0 comments

Recent Posts

See All

Going Dual Z-Axis

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Two Cetus's Functional, One to go, Rebuilding Code

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr


bottom of page