top of page

More Updates!

Behold, the remote drive hat on top of the hot end as well as the swappable option of an impressive 3.5" touch screen. I also made some general tweaks throughout the frame to ensure the build volume was a little larger than advertised and cleared some cases of collisions.

My next plan is to probably add some timing belts to the model to make the model look nicer and probably get to adding the vibration dampeners I have had planned. Basic idea is to flush out the website with some renders before replacing them with real pictures.

I hope all is well to whoever is reading this, cheers!

1 view0 comments

Recent Posts

See All

Going Dual Z-Axis

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Two Cetus's Functional, One to go, Rebuilding Code

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr


bottom of page