top of page
Search

Firmware Uploaded!


I finally sorted visual studio and its extensions out. The first few uploads were me trying to figure out why the bin file was not converting to a cur file. Now I am stuck with a blank full graphic controller that ticks but does not light up.


So far I am happy I haven't gotten any magic smoke and I will try swapping some blank boards and screens to see if there are different results.


Cheers!

0 views0 comments

Recent Posts

See All

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr

bottom of page