top of page
Search

Dry Box Progress


I am eyeballing the design at the moment. I recently added a desiccant tray and o-ring slot for respectively an easy desiccant removing and a tight air seal between the lid and base. So far looking good, not quite done yet.


Cheers!

0 views0 comments

Recent Posts

See All

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr

bottom of page