top of page

Worm drive success!

Woo! It spins, it fits, it smooth af. Today is a good day, I am printing out a worm gear set for each printer because I am onto some good stuff. I am still letting paranoia get to me and I am worried about the flexible drive shaft not turning smoothly but one hurdle at a time. I have motion, I almost have the extruder dialed in, I am feeling like I can get this printer done before the end of the month.


1 view0 comments

Recent Posts

See All

Going Dual Z-Axis

There is just no easy way to put this but I am just not happy with the how choppy the z-axis movement is with only one lead screw and motor. I am halting a lot of progress in the printer by just not a

Two Cetus's Functional, One to go, Rebuilding Code

Been a busy week between classwork and finishing up with the Cetus's. Two of them have been printing fairly reliably now so long as I feed them +/-0.02-0.03mm filament instead of +/-0.05mm filament fr


bottom of page